When a furnace won't light, keeps shutting off, or the limit switch keeps tripping, resetting it doesn't fix the cause. Every Furnace Repair visit includes a carbon monoxide safety check before we leave, not an upsell.
Furnace failures cluster heavily around a handful of parts — ignitors, flame sensors, gas valves, and heat exchangers — and most no-heat calls come down to one of those four. We test each with a multimeter and combustion analyzer rather than replacing parts on a hunch.
Safety and accuracy on every heating call.
Every furnace repair includes a combustion analyzer reading to check for dangerous CO levels, not an optional add-on.
We bump no-heat calls ahead of routine work when temperatures drop, especially in peak winter.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Whether the furnace runs on gas or electric heat strips, our techs are trained on both, so the fuel type never determines who gets sent.
Six repairs that cover most of our winter service calls.
Cracked ignitors and carbon-fouled flame sensors account for a large share of no-heat calls, and both are usually same-visit fixes.
We test gas valve response and pressure output rather than replacing an expensive part on a hunch, since these parts are costly enough to warrant confirming the fault first.
Because a cracked heat exchanger can leak combustion byproducts into the home's air, we inspect it carefully with a scope and analyzer rather than assuming based on age alone.
Short-cycling or mid-cycle shutdowns frequently trace back to the limit switch or a struggling blower motor — we test both before condemning the control board.
We still service standing-pilot furnaces, checking thermocouple output and draft conditions that newer ignition systems don't have.
Zero response from the furnace can mean a wiring fault or thermostat issue rather than the furnace itself — we rule this out early to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Describe the symptom — no heat, short-cycling, a smell — and we schedule the nearest available tech.
A stocked truck arrives in your confirmed window ready to diagnose and often repair on the spot.
We run the safety and diagnostic checks first, then present a flat-rate quote for your approval.
Repairs typically wrap same visit, and we re-check CO levels before signing off, backed by our labor warranty.
Feedback from completed furnace repairs.
Furnace kept shutting off every twenty minutes. Their technician found a dirty flame sensor and cleaned it, been running fine for two months now.
— B. Halloran, homeowner
They caught a hairline crack in the heat exchanger during a routine repair call and walked me through the safety concern honestly, not to upsell.
— V. Ashworth, homeowner
No heat during the coldest week of the year, they got someone out same day and had it fixed within an hour, ignitor replacement.
— Q. Delrio, homeowner
Old standing pilot furnace that most companies don't want to touch anymore. They knew exactly what they were doing, thermocouple was the issue.
— E. Vantassel, homeowner
Common questions before a Furnace Repair visit.
Clicking or humming without ignition often points to the ignitor, though we always confirm with a proper resistance reading before quoting.
It's a genuine safety concern since it can let combustion byproducts into the airflow, so we take the inspection seriously and won't operate a confirmed-cracked unit.
Every furnace call includes a CO check with a combustion analyzer, no extra charge.
We still service standing-pilot units, including thermocouple and draft-related repairs.
No-heat calls get priority routing, typically same-day during winter demand even during high-demand cold weather.
Common failure parts ride on the truck already; something unusual might mean a next-day return visit to complete the repair.
We dispatch heating techs throughout Port Jervis and the surrounding zips — call to confirm availability.
Call +1-844-611-2875
